| Info |
|---|
TAs: Deniz Aktas, Emine Bardakci |
...
Figure 4: Pancake, compression load cell
2. Pre-Lab Quiz
Quiz Date: xxxxxx
XXXXXXXXXXXXXXXXXXXXXXXXX
...
Before programming with the NI ELVIS III, you must first create an NI ELVIS III project. With an NI ELVIS III project, you can group together all the files relevant to your application and run VIs on the NI ELVIS III.
Safety
Be aware of powering the NI board and be aware of not creating any short circuit on the board (connecting ground and power levels (+5V, 3.3V) is not recommended, and may create some damage on the electronic components, be careful about that.)
Hardware/Software Equipment Check
Prior to starting the lab, make sure the equipment is working by conducting the following steps:
Step 1: Make sure that the NI setup is open from the ON/OFF switch as it found at the back of the device.
Step 2: Make sure that you press the open button on the device.
3. Data Collection
Part 1 Strain Sensors
...
o All leds light when applied force is greater than 30N.
Safety
Be aware of powering the NI board and be aware of not creating any short circuit on the board (connecting ground and power levels (+5V, 3.3V) is not recommended, and may create some damage on the electronic components, be careful about that.)
Hardware/Software Equipment Check
Prior to starting the lab, make sure the equipment is working by conducting the following steps:
Step 1: Make sure that the NI setup is open from the ON/OFF switch as it found at the back of the device.
Step 2: Make sure that you press the open button on the device.
5. Post-Lab Report
Due Date: xxxxxx
...